Support
Support
Applications
Third Party
2013-03-06
◥ SCADA HMI ◥ Fatek OPC Server
Simple human-machine interface and RFID card
2012-11-19
FB-DAP can be used for setting Timer/Counter and displaying NC position. It also can be used for simple human-machine interface by using the features of user defi nable key and display message. The FB-DAP with -R option is equipped with wireless card reader module and can be used for the application of entrance , elevator, security control and calling car in parking tower. Besides, FB-DAP uses extra-large membrane keypad, which is easy to be distinguished and operated.
7/16-segment LED display module
2012-11-19
The FBs-7SG is a 7/16-segment LED display module with only 4cm width. The embedded I/O ASIC chips will automatically conduct the multiplexing scan display of two sets of 8 digits (a total of 16 digits) 7-segment LED display or 8 sets of 16-segment LED display without occuping CPU time. The multiplexing scan time is 10ms. Furthermore, because of multiplexing scan, each set of 8 digits (64bit LED) only requires the 16pins ribbon cables for connection. Three different driving voltages and three voltage fi ne tuning are available in this module, which are capable of driving most of existing 7-segment LED displays of which the driving voltage is various. The installation distance of display can even reach up to one hundred meters. FATEK also provides 4(.56”, .8”, 2.3”, and 4.0”) 7-segment LED display boards and 2(.8”, 2.3”) 16-segment alphanumeric LED display for the choice of users.
Thumbwheel switch multiplex input
2012-11-19
The FBs-32DGI thumbwheel switch multiplex input module provided in FBs-PLC conduct multiplexing input scan of the eight sets of 4 digit numbers (or 128 independent ON/OFF status) via the embedded I/O ASIC chips (special chips for the FBs-PLC I/O module). It does not occupy any CPU time and the multiplexing scan rate is about 10ms. In addition, because only 24 wires are required by multiplexing input to achieve 32 digits (or 128 bit ON/OFF) input, plus that the FBs-32DGI is only 4cm in width, it turn out to be an ultra high density, lowest cost, and most labor saving solution.
Temperature measurement and PID control
2012-11-19
The FBs-PLC provides a thermocouple temperature modules (for J,K,R,S,E,T,B,N thermocouples) as well as a RTD temperature module(for Pt-100 and Pt-1000 RTD). Thermocouples are suitable for the measurement of large temperature ranges such as a boiler process. RTD’s are good for the measurement of low temperature, smaller ranges of temperature and higher resolution such as refrigeration and air conditioning applications. Due to the characteristics of temperature control, adopting multiplexing scan measurement and multiple loop PID control make a single FBs-PLC capable of performing up to 32 loops of PID temperature control. With the convenient instruction of temperature measurement and temperature PID control in the ladder program development software signifi cantly reduce the diffi culty, cost and time of developing and testing monitoring and control programs.